Introducing MacEwen3D Tel: 716-727-8393
Upgraded Stainless Steel Extruder Gear for Creality Cr-10, Ender 2, Ender 3, Afinibot

Upgraded Stainless Steel Extruder Gear for Creality Cr-10, Ender 2, Ender 3, Afinibot

MacEwen3D

Normaler Preis $7.99 $5.25 Angebot

We are proud to announce a terrific upgrade to the stock brass 'extruder' gear, found on many Creality printers.  This is a single gear made from hard stainless steel.  It has 36 teeth.  This gear a a great replacement for the stock brass gear, and cheaper alternative to our hard steel gear.   It can be used in any CR-10. S4, S5, Ender, Ender 2, Ender 3, Afinibot, and many more.  It works with stock plastic extruder, and is a simple swap. 

If you are experiencing wear on your brass gear, upgrade to this.  The stock gear diameter is 10.9mm.  This stainless steel gear is 10.9 mm.   The teeth on this gear are not as sharp a point as our hard steel gear.  Your stock profiles will work very well with this gear.  This is an upgrade.

This item includes:

1 Stainless Steel Gear with set screw.

NOTE: Please be aware that in the instance of these types of drive feed gears, tooth count is not relevant to feeding ratio (speed).  Not all drive gears made have the same tooth pitch (tooth size).  What is helpful to know, is the effective diameter of the gear.  This effective diameter is what helps to determine your drive feed speed.  We recommend 36T gears, if they are steel, for these printers, since they are a good balance of grip, and wear resistance.