terations to the stock hardware or firmware needed. I've completed about 6 good sized tpu prints since installing with no issues. I also updated my print profile to just use my PLA settings and just changing my hot-end temps (retractions are on). I can't imagine running my setup without this extruder. I didn't have to do anything drastic to make it work like altering my machine to do direct drive or having to load special firmware to support a complicated extruder etc... Read LessRead less about My previous setup was a stock except a
I will switch it and hope I'm good. It works too well and partly shreds the e-sun PETG, no other filaments tested. Your mileage may vary. Read LessRead less about Bought this to replace my worn brass